Select the name of the seismic survey. To change the order in which options in this list are displayed, use the Sort by option. To reduce the actual volume of seismic sections from which to choose, refer to the Survey Retrieval option below.

Select from the various versions of the seismic line that may be available. Entries in this list include versions that may have been migrated, to which particular filters are applied, etc.

Specify an are around the wellbore around which to retrieve the surveys where increasing the radius increases the volume of selections available in the top-left drop-down list of the Import Kingdom Seismic dialog box.

Select whether to automatically pull traces or surface positions from the seismic for a given line that falls within a certain distance from the well. These can either be selected by line and opposing cross line, the entire line or cross line within a range, or by a given radius around the well, which will include both lines and cross lines.
If the Select data within check box is cleared, data can be retrieved from only a line or cross line instead of a radius.
Refer to the Kingdom base map for line and cross line numbering.

Type the duration of data to retrieve from Kingdom. The maximum duration is up to 4 seconds of data. 4 seconds is a large volume of data, perhaps 100,000 feet down. 2 seconds is likely a more appropriate volume of data.

Select whether to tie the data to the surface or bottom hole location. The bottom hole location is typically closest to the reservoir target.